TS-7250-V3 DIO Header: Difference between revisions

From embeddedTS Manuals
No edit summary
No edit summary
Line 66: Line 66:


[[File:KPAD.jpg|200px|right]]
[[File:KPAD.jpg|200px|right]]
The SPI bus on this header can be disabled by changing the [[#FPGA Syscon|FPGA Syscon 0x08 bit 10]]:
<source lang=bash>
​tshwctl -a 0x8 --poke32 0x400
</source>


The DIO header is designed to provide compatibility with the KPAD accessory.  This is a 4x4 numerical keypad.  This is supported in userspace with the [https://github.com/embeddedTS/ts7100-utils/blob/master/src/keypad.c keypad.c] source code, or the "keypad" utility which is included in the shiping image.
The DIO header is designed to provide compatibility with the KPAD accessory.  This is a 4x4 numerical keypad.  This is supported in userspace with the [https://github.com/embeddedTS/ts7100-utils/blob/master/src/keypad.c keypad.c] source code, or the "keypad" utility which is included in the shiping image.

Revision as of 13:09, 20 March 2023

The DIO header is a 0.1" pitch 2x8 header including SPI and GPIO. All pins on this header are 5V tolerant except SPI output pins. All of these DIO includes pullups.

Signals Pin Layout
Pin Signal
1 GPIO Bank 5 IO 1
2 GND
3 GPIO Bank 5 IO 2
4 Current Sink Output Bank 0 IO 30 [1]
5 GPIO Bank 5 IO 3 / ttyS14 TX
6 spidev 4.0 Chip Select / GPIO Bank 5 IO 11
7 GPIO Bank 5 IO 4 / ttyS14 RX
8 GPIO Bank 5 IO 5
9 GPIO Bank 5 IO 6 / ttyS15 TX
10 spidev 4.0 MISO / GPIO Bank 5 IO 10 [2]
11 GPIO Bank 5 IO 7 / ttyS15 RX
12 spidev 4.0 MOSI / GPIO Bank 5 IO 15
13 GPIO Bank 5 IO 8 / ttyS14 TXEN
14 spidev 4.0 CLK / GPIO Bank 5 IO 14
15 GPIO Bank 5 IO 9 / ttyS15 TXEN
16 3.3V

TS-7250-V3-DIO Header.svg

  1. ↑ When this pin is a high output it enables a FET to ground.
  2. ↑ This pin is input only even when in the GPIO mode
KPAD.jpg

The SPI bus on this header can be disabled by changing the FPGA Syscon 0x08 bit 10: 

​tshwctl -a 0x8 --poke32 0x400

The DIO header is designed to provide compatibility with the KPAD accessory. This is a 4x4 numerical keypad. This is supported in userspace with the keypad.c source code, or the "keypad" utility which is included in the shiping image.

This debounces presses to 50ms, and does not repeat when numbers are held. This will output a string containing the key that is pressed. Eg: 

root@tsimx6:~# keypad
1
UP
DOWN
2ND
ENTER
Retrieved from "http://docs.embeddedTS.com/index.php?title=TS-7250-V3_DIO_Header&oldid=15868"