TS-7250-V3 DIO Header

The DIO header is a 0.1" pitch 2x8 header including SPI and GPIO. All pins on this header are 5V tolerant except SPI output pins. All of these DIO includes pullups.

Signals	Pin Layout
Pin Signal 1 GPIO Bank 5 IO 1 2 GND 3 GPIO Bank 5 IO 2 4 Current Sink Output Bank 0 IO 30 5 GPIO Bank 5 IO 3 / ttyS14 TX 6 spidev 4.0 Chip Select 7 GPIO Bank 5 IO 4 / ttyS14 RX 8 GPIO Bank 5 IO 5 9 GPIO Bank 5 IO 6 / ttyS15 TX 10 spidev 4.0 MISO 11 GPIO Bank 5 IO 7 / ttyS15 RX 12 spidev 4.0 MOSI 13 GPIO Bank 5 IO 8 / ttyS14 TXEN 14 spidev 4.0 CLK 15 GPIO Bank 5 IO 9 / ttyS15 TXEN 16 3.3V

The DIO header is designed to provide compatibility with the KPAD accessory. This is a 4x4 numerical keypad. This is supported in userspace with the keypad.c source code, or the "keypad" utility which is included in the shiping image.

This debounces presses to 50ms, and does not repeat when numbers are held. This will output a string containing the key that is pressed. Eg:

root@tsimx6:~# keypad
1
UP
DOWN
2ND
ENTER