TS-8150 Serial Console: Difference between revisions
(Created page with "The TS-8150 console is an RS232 UART at 115200 baud, 8n1 (8 data bits 1 stop bit), and no flow control. On the TS-8150 you need to set the "Console Enable" jumper as pictured...") |
(Clarified documentation, identified incorrect picture.) |
||
Line 1: | Line 1: | ||
The TS-8150 console is an RS232 UART at 115200 baud, 8n1 (8 data bits 1 stop bit), and no flow control. On the TS-8150 you need to set the "Console Enable" jumper as pictured: | The TS-8150 console is an RS232 UART at 115200 baud, 8n1 (8 data bits 1 stop bit), and no flow control. You will need a NULL MODEM cable. On the TS-8150 you need to set the "Console Enable" jumper as pictured: | ||
{| | {| | ||
| [[File:TS-8100-ConsoleEnable.jpg|300px]] | | [[File:TS-8100-ConsoleEnable.jpg|300px]] | ||
|} | |} | ||
Note: TS-8100 pictured above, your product may vary slightly in placement and nomenclature. | |||
This will bring the console UART to both the [[#DB9 Port|DB9 Port]], and the [[#COM1 Header|COM1 Header]]. | This will bring the console UART to both the [[#DB9 Port|DB9 Port]], and the [[#COM1 Header|COM1 Header]]. |
Latest revision as of 12:31, 15 September 2014
The TS-8150 console is an RS232 UART at 115200 baud, 8n1 (8 data bits 1 stop bit), and no flow control. You will need a NULL MODEM cable. On the TS-8150 you need to set the "Console Enable" jumper as pictured:
Note: TS-8100 pictured above, your product may vary slightly in placement and nomenclature.
This will bring the console UART to both the DB9 Port, and the COM1 Header.
Note: | If DIO_9 is held low during boot until the red LED comes on (around 5 seconds), console will be redirected to XUART 0. On the TS-8150 DIO9 is installed as a push switch if the second ethernet is not installed. |
Console from Linux
There are many serial terminal applications for Linux, three common used applications are picocom
, screen
, and minicom
. These examples demonstrate all three applications and assume that the serial device is "/dev/ttyUSB0" which is common for USB adapters. Be sure to replace the serial device string with that of the device on your workstation.
picocom
is a very small and simple client.
sudo picocom -b 115200 /dev/ttyUSB0
screen
is a terminal multiplexer which happens to have serial support.
sudo screen /dev/ttyUSB0 115200
Or a very commonly used client is minicom
which is quite powerful but requires some setup:
sudo minicom -s
- Navigate to 'serial port setup'
- Type "a" and change location of serial device to "/dev/ttyUSB0" then hit "enter"
- If needed, modify the settings to match this and hit "esc" when done:
E - Bps/Par/Bits : 115200 8N1 F - Hardware Flow Control : No G - Software Flow Control : No
- Navigate to 'Save setup as dfl', hit "enter", and then "esc"
Console from Windows
Putty is a small simple client available for download here. Open up Device Manager to determine your console port. See the putty configuration image for more details.