TS-1700
 | |||
| Released Mar. 2011 | |||
| Product Page | |||
| Documentation | |||
|---|---|---|---|
| Schematic | |||
| Mechanical Drawing | |||
| FTP Path | |||
| DIO | |||
| 8 | |||
| External Interfaces | |||
| 2x RJ45 Modbus | |||
| Power Requirements | |||
| 12-24V | |||
| Operates around ?? | |||
| Operating Temperature | |||
| |||
| |||
| Mechanical | |||
| ???mm x ???mm | |||
| Height ???mm (approx without baseboard) | |||
| Weight ??? | |||
Overview
The TS-1700 is a modbus peripheral device which brings out 8 DIO, or 8 one wire temperature sensors.
Getting Started
Features
Legacy Support
TS Modbus Support
When using all Technologic Systems Modbus devices we include functionality to create an arbitrary chain of stock peripherals to automatically enumerate all connected devices, configure them them, and generate an I/O map of all connected devices.
TS Modbus Autoconfiguration
The
1-Wire host
Holding Registers
The holding registers include various settings such as the configurable Modbus Address, termination enable, and more. These settings are common to all of our Modbus peripherals, and are stored in flash to persist between power cycles.
The Modbus protocol supports 64K
| Address | Access | Description | Example Values |
| 0x70 | Read/Write | Modbus Mode | 0 = ASCII, 1 = RTU |
| 0x71 | Read/Write | RS485 Bus Termination Enable | 0 = No termination, 1 = enable termination |
| 0x72 | Read/Write | Modbus Device Address |
Connectors =
2x RJ45
Product Notes
FCC Advisory
This equipment generates, uses, and can radiate radio frequency energy and if not installed and used properly (that is, in strict accordance with the manufacturer's instructions), may cause interference to radio and television reception. It has been type tested and found to comply with the limits for a Class A digital device in accordance with the specifications in Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference when operated in a commercial environment. Operation of this equipment in a residential area is likely to cause interference, in which case the owner will be required to correct the interference at his own expense.
If this equipment does cause interference, which can be determined by turning the unit on and off, the user is encouraged to try the following measures to correct the interference:
Reorient the receiving antenna. Relocate the unit with respect to the receiver. Plug the unit into a different outlet so that the unit and receiver are on different branch circuits. Ensure that mounting screws and connector attachment screws are tightly secured. Ensure that good quality, shielded, and grounded cables are used for all data communications. If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The following booklets prepared by the Federal Communications Commission (FCC) may also prove helpful:
How to Identify and Resolve Radio-TV Interference Problems (Stock No. 004-000-000345-4) Interface Handbook (Stock No. 004-000-004505-7) These booklets may be purchased from the Superintendent of Documents, U.S. Government Printing Office, Washington, DC 20402.
Limited Warranty
See our Terms and Conditions for more details.