TS-4200
From embeddedTS Manuals
 | |
| Released Mar. 2011 | |
| Product Page | |
| Documentation | |
|---|---|
| Schematic | |
| Mechanical Drawing | |
| FTP Path | |
| CPU Datasheet | |
| CPU Manual | |
| CPU Technical Reference Manual |
Syscon
| Offset | Bits | Usage |
|---|---|---|
| 0x0 | 15:0 | Model ID: Reads 0x4200 |
| 0x2 | 15 | Green LED (1 = on) |
| 14 | Red LED (1 = on) | |
| 13:8 | Reserved | |
| 7:4 | Board Sub-model: reads 0x0 on standard unit | |
| 3:0 | FPGA revision | |
| 0x4 | 15:0 | DIO direction for DIO 15(MSB)-0(LSB) |
| 0x6 | 15:0 | DIO output data for DIO 15(MSB)-0(LSB) |
| 0x8 | 15:0 | DIO input data for DIO 15(MSB)-0(LSB) |
| 0xa | 15:12 | Reserved |
| 11 | UART0 9 bit mode (so that TX_EN works correctly) | |
| 10 | 1 = use DIO12 for uart0 TX_EN instead of DIO | |
| 9 | 1 = use 512Hz for WDT instead of 200Hz | |
| 8 | 1 = auto reboot when DIO 9 is driven low (enable reset button) | |
| 7:6 | Scratch Register (used by bootrom) | |
| 5:4 | Mode strapping inputs Mode2 and Mode1 | |
| 3 | Reserved | |
| 2 | 1 = Enable power to Ethernet PHY | |
| 1 | 1 = Enable power to SD card | |
| 0 | Offboard reset signal (1 = reset) | |
| 0xc | 15:0 | 32-bit 1MHz free running counter (16 LSBs) |
| 0xe | 15:0 | 32-bit 1MHz free running counter (16 MSBs) |
| 0x10 | 15:0 | Watchdog feed register |
| 0x12 | 15:0 | DIO direction for DIO 31(MSB) - 16(LSB) |
| 0x14 | 15:0 | DIO output data for DIO 31(MSB) - 16(LSB) |
| 0x16 | 15:0 | DIO input data for DIO 31(MSB) - 16(LSB) |
| 0x18 | 15:0 | Hardware RNG (16 LSB) |
| 0x1a | 15:0 | Hardware RNG (16 MSB) |
| 0x1c | 15 | Embedded FlashROM CLK |
| 14:8 | Embedded FlashROM Address | |
| 7:0 | Embedded FlashROM Data Byte | |
| 0x1e | 15:0 | UART0 baud rate divisor (for UART0 TX_EN) |
| 0x20 | 15:0 | MUXBUS configuration register |
| 0x22 | 15:0 | IRQ register |
| 0x24 | 15:0 | IRQ mask register |