TS-4800 LEDs: Difference between revisions
From embeddedTS Manuals
(Created page with "On all of our baseboards we include 2 indicator LEDs which are under software control. You can manipulate these using "ts4800ctl --greenledon --redledon" or "ts4800ctl --gree...") |
m (Links auto-updated for 2022 re-branding ( http://www.embeddedarm.com/about/rma.php → http://www.embeddedTS.com/about/rma.php)) |
||
Line 20: | Line 20: | ||
| Off | | Off | ||
| Off | | Off | ||
| The FPGA is not able to start. Typically either the board is not being supplied with enough voltage, or the FPGA has been otherwise damaged. If a stable 5V is being provided and the supply is capable of providing at least 1A to the macrocontroller, an [http://www. | | The FPGA is not able to start. Typically either the board is not being supplied with enough voltage, or the FPGA has been otherwise damaged. If a stable 5V is being provided and the supply is capable of providing at least 1A to the macrocontroller, an [http://www.embeddedTS.com/about/rma.php RMA] is suggested. | ||
|- | |- | ||
| On | | On |
Revision as of 16:53, 17 January 2022
On all of our baseboards we include 2 indicator LEDs which are under software control. You can manipulate these using "ts4800ctl --greenledon --redledon" or "ts4800ctl --greenledoff --redledoff". The LEDs have 4 behaviors from default software.
Green Behavior | Red behavior | Meaning |
---|---|---|
On | Off | System is booted and running |
On | On for approximately 15s, then off | Once the system has booted the kernel and executed the startup script, it will check for a USB device and then determine if it is a mass storage device. This is used for updates/blasting through USB. Once it determines this is not a mass storage device the red LED will turn back off. |
On | Turns on for 300ms, and then turns off for 10s | The watchdog is continuously resetting the board. This happens when the system cannot find a valid boot device, or the watchdog is otherwise not being fed. This is normally fed by ts4800ctl once a valid boot media has started. See the #Watchdog section for more details. |
Off | Off | The FPGA is not able to start. Typically either the board is not being supplied with enough voltage, or the FPGA has been otherwise damaged. If a stable 5V is being provided and the supply is capable of providing at least 1A to the macrocontroller, an RMA is suggested. |
On | On | The board is receiving too little power, or something is drawing too much current from the macrocontroller's power rails. |