TS-7250-V3 MikroBus Header

The Mikrobus header is a 0.1" pitch 2x8 header which supports the Mikroe Click board ecosystem. This header features 3.3 V, 5 V, SPI, GPIO, ADC, PWM, a UART, and PWM. All I/O on this header are FPGA 3.3-V LVTTL.

The Click boards™ standard (where Click boards™ are a modular prototyping add-on board) is openly documented, allowing for custom boards to be designed.

By default all of these headers default to their non-gpio functions. These can be changed in the FPGA syscon register 0x08. For example:

# Make all mikrobus header pins GPIO:
peekpoke 32 0x50004008 0xF0

# Set only SPI to GPIO:
peekpoke 32 0x50004008 0x10

Signals

Pin Layout

Pin Signal 1 #FPGA_ADC / GPIO Chip 50004054.fpga_gpio IO 1 2 (MIKRO_RESET#) GPIO Chip 50004054.fpga_gpio IO 0 3 spidev 5.0 CS# / GPIO Chip 50004054.fpga_gpio IO 5 4 spidev 5.0 CLK / GPIO Chip 50004054.fpga_gpio IO 6 5 spidev 5.0 MISO / GPIO Chip 50004054.fpga_gpio IO 7 6 spidev 5.0 MOSI / GPIO Chip 50004054.fpga_gpio IO 8 7 3.3V 8 GND 9 GND 10 5V 11 /dev/i2c-4 DAT / GPIO Chip 50004054.fpga_gpio IO 11 12 /dev/i2c-4 CLK / GPIO Chip 50004054.fpga_gpio IO 12 13 ttyS13 TXD / GPIO Chip 50004054.fpga_gpio IO 9 14 ttyS13 RXD / GPIO Chip 50004054.fpga_gpio IO 10 15 FPGA IRQ 18 / GPIO Chip 50004054.fpga_gpio IO 2 16 MIKRO_PWM / GPIO Chip 50004054.fpga_gpio IO 4