TS-7250-V3 TS-MULTI-104
From embeddedTS Manuals
 | |
| Product Page | |
| 8-bit IO |
|---|
The TS-MULTI-104 supports serial based Multitech Socketmodems for cellular support.
The TS-MULTI-104 implements 16550A based UART which require a kernel driver. Under Linux this requires a device tree change. See the Kernel compile section for more details about getting set up the compile the kernel.
This below example will set up the serial devices for a TS-MULT-104 with the IRQ6, COM1, and 1.8MHz jumpers installed. Open the device tree at arch/arm/boot/dts/imx6ul-ts7250v3.dts. Add the highlighted section to the device tree and recompile.
pc104bus: fpgaisa@50 {
compatible = "technologic,pc104-bus";
reg = <0x50 0x4>;
ranges = <0 0 0x1000>;
reset-gpio = <&gpio3 7 0>;
#address-cells = <0x1>;
#size-cells = <0x1>;
status = "okay";
/* TS-MULTI-104 */
ts16550@3f8 {
compatible = "technologic,ts16550";
reg = <0x3f8 8>;
interrupt-parent = <&fpga_intc>;
interrupts = <15>;
status = "okay";
};
};
On the next boot check the "dmesg" output to verify it loaded:
root@tsimx6:~# dmesg | grep ts16550 [ 2.259413] ts16550 50004050.fpgaisa:ts16550@3f8: Adding 16550 UART ttyS0
The device node /dev/ttyS0 can be used to access this UART.