From embeddedTS Manuals
Revision as of 20:41, 14 January 2021 by Lionel (talk | contribs) (FTP links auto-updated (http://www.embeddedarm.com/documentation/ →‎ https://cdn.embeddedarm.com/resource-attachments/))
Product Page
1.7" x 3.5"

1 Introduction

The TS-ETH10 a PC/104 daughter card that provides one 10 base-T

  • Ethernet adapter running at 10 MBit.
  • I/O address and IRQ’s are jumper selectable (IRQ’s 5, 6, 7 & 12 available)
  • Cirrus CS8900 16-bit Ethernet chip with settings saved in EEPROM
  • Indicator LED’s for link and activity.
  • Linux , NetBSD and DOS drivers available.

2 Jumpers and IRQs

I/O address selection
Add1 Add2 I/O Address
Off Off 0x300
Off On 0x310
On Off 0x320
On On 0x330
IRQ jumper IRQ selected
None 12
IRQ5 5
IRQ6 6
IRQ7 7
Note: The 64Pin jumper allows TS-7000 (ARM) products to interface with the TS-ETH10 in 16-bit mode using an 8-bit (64 pin) connector. All other (x86) products require the full 104 pin PC/104 connector.

3 Product Notes

3.1 FCC Advisory

This equipment generates, uses, and can radiate radio frequency energy and if not installed and used properly (that is, in strict accordance with the manufacturer's instructions), may cause interference to radio and television reception. It has been type tested and found to comply with the limits for a Class A digital device in accordance with the specifications in Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference when operated in a commercial environment. Operation of this equipment in a residential area is likely to cause interference, in which case the owner will be required to correct the interference at his own expense.

If this equipment does cause interference, which can be determined by turning the unit on and off, the user is encouraged to try the following measures to correct the interference:

Reorient the receiving antenna. Relocate the unit with respect to the receiver. Plug the unit into a different outlet so that the unit and receiver are on different branch circuits. Ensure that mounting screws and connector attachment screws are tightly secured. Ensure that good quality, shielded, and grounded cables are used for all data communications. If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The following booklets prepared by the Federal Communications Commission (FCC) may also prove helpful:

How to Identify and Resolve Radio-TV Interference Problems (Stock No. 004-000-000345-4) Interface Handbook (Stock No. 004-000-004505-7) These booklets may be purchased from the Superintendent of Documents, U.S. Government Printing Office, Washington, DC 20402.

3.2 Limited Warranty

See our Terms and Conditions for more details.