8160-gettingstarted
From embeddedTS Manuals
Before attempting to apply power to the baseboard, perform the following steps while taking proper static discharge precautions
- Place the TS-8160 base board on a firm non-conductive surface.
- Place the COM1 "Console Enable" jumper in the console position so the debug port is brought out to the DB9 and COM1 headers.
- Carefully, insert the System-on-Module by aligning and pressing evenly and firmly onto the pair of mating connectors
- Connect the console serial terminal cable
- Connect the Ethernet cable is applicable.
- Apply power
- Monitor the TS-SOCKET SBC using a terminal emulator connected to the serial console port to verify that the board is operating properly