Lenny Network configuration

From almost any Linux system you can use "ip" or the ifconfig/route commands to initially set up the network. To configure the network interface manually you can use the same set of commands in the initrd or Debian.

# Bring up the CPU network interface
ifconfig eth0 up

# Or if you're on a baseboard with a second ethernet port, you can use that as:
ifconfig eth1 up

# Set an ip address (assumes 255.255.255.0 subnet mask)
ifconfig eth0 192.168.0.50

# Set a specific subnet
ifconfig eth0 192.168.0.50 netmask 255.255.0.0

# Configure your route.  This is the server that provides your internet connection.
route add default gw 192.168.0.1

# Edit /etc/resolv.conf for your DNS server
echo "nameserver 192.168.0.1" > /etc/resolv.conf

Most commonly networks will offer DHCP which can be set up with one command:

Configure DHCP in Debian:

# To setup the default CPU ethernet port
pump -i eth0
# Or if you're on a baseboard with a second ethernet port, you can use that as:
pump -i eth1

Configure DHCP in the initrd:

udhcpc -i eth0
# Or if you're on a baseboard with a second ethernet port, you can use that as:
udhcpc -i eth1

To make your network settings take effect on startup in Debian, edit /etc/network/interfaces:

 # Used by ifup(8) and ifdown(8). See the interfaces(5) manpage or 
 # /usr/share/doc/ifupdown/examples for more information.          
                                                                   
 # We always want the loopback interface.                          
 #                                                                 
 auto lo                                                           
 iface lo inet loopback                                            
                                                                   
 auto eth0                                                         
 iface eth0 inet static                                            
   address 192.168.0.50                                            
   netmask 255.255.255.0                                           
   gateway 192.168.0.1                                             
 auto eth1                                                         
 iface eth1 inet dhcp

In this example eth0 is a static configuration and eth1 receives its configuration from the DHCP server. For more information on network configuration in Debian see their documentation here.

To make your changes permanent in the initrd you will need to edit the linuxrc script. Use the same commands you would use to manually configure it and place them over the current ifconfig calls.