TS-7680 uboot

U-Boot is used on this device as the bootloader to launch the full operating system. When the i.MX28 processor starts, it loads U-Boot from the on-board SPI flash. This allows creation of a custom boot image on either the SD, eMMC, NFS, or USB. U-Boot is a general purpose bootloader that is capable of booting into common Linux distributions, Android, Windows, or custom software OSes.

On a normal boot the output will be similar to this:

HTLLCLLC

U-Boot 2014.10-g4d36657 (Dec 07 2016 - 12:19:27)

CPU:   Freescale i.MX28 rev1.2 at 454 MHz
BOOT:  SSP SPI #2, master, 3V3 NOR
I2C:   ready
SPI:   ready
DRAM:  256 MiB
MMC:   MXS MMC: 0, MXS MMC: 1
SF: Detected IS25LQ016B with page size 256 Bytes, erase size 4 KiB, total 2 MiB

In:    serial
Out:   serial
Err:   serial
Net:   FEC0 [PRIME]
NO CHRG jumper is set, not waiting for SuperCaps to charge
Booting from the SD Card ...
** File not found /boot/boot.ub **
3336928 bytes read in 1245 ms (2.6 MiB/s)
20378 bytes read in 265 ms (74.2 KiB/s)
## Booting kernel from Legacy Image at 42000000 ...
   Image Name:   Linux-3.14.28-g1a4251b
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    3336864 Bytes = 3.2 MiB
   Load Address: 40008000
   Entry Point:  40008000
   Verifying Checksum ... OK
## Flattened Device Tree blob at 41000000
   Booting using the fdt blob at 0x41000000
   Loading Kernel Image ... OK
   Loading Device Tree to 4fb4b000, end 4fb52f99 ... OK

Starting kernel ...