TS-9422
 | |
| Product Page | |
| Documents | |
|---|---|
| Schematic |
Introduction
TS-9422 is a software debugging tool for use on any PC/104 system. It displays POST codes on two 7-segment LEDs. The default I/O location is the PC standard location of Hex 80. By installing jumper # JP5, the decoded I/O location is changed to location Hex 9D. This provides a unique address for the user's program to use during debug. This peripheral is designed for use with Technologic Systems' x86 SBC's.
- Two 7-segment LEDs
- PC/104 8-bit bus
- Standard PC I/O address
- Jumper selectable I/O address
- Dimensions 3.375x1.375 inches
Hardware Configuration
Usage
Insert the TS-9422 in to the SBC it is to be used with, making sure to align all of the pins as well as taking note of the orientation using the mounting holes. Inserting the peripheral board backwards may cause damage. The two seven segment display will display the byte wide value stored at I/O address 80h which is used in x86 to display POST codes. The TS-9422 will display values at 9Dh if JP5 is installed.
Product Notes
FCC Advisory
This equipment generates, uses, and can radiate radio frequency energy and if not installed and used properly (that is, in strict accordance with the manufacturer's instructions), may cause interference to radio and television reception. It has been type tested and found to comply with the limits for a Class A digital device in accordance with the specifications in Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference when operated in a commercial environment. Operation of this equipment in a residential area is likely to cause interference, in which case the owner will be required to correct the interference at his own expense.
If this equipment does cause interference, which can be determined by turning the unit on and off, the user is encouraged to try the following measures to correct the interference:
Reorient the receiving antenna. Relocate the unit with respect to the receiver. Plug the unit into a different outlet so that the unit and receiver are on different branch circuits. Ensure that mounting screws and connector attachment screws are tightly secured. Ensure that good quality, shielded, and grounded cables are used for all data communications. If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The following booklets prepared by the Federal Communications Commission (FCC) may also prove helpful:
How to Identify and Resolve Radio-TV Interference Problems (Stock No. 004-000-000345-4) Interface Handbook (Stock No. 004-000-004505-7) These booklets may be purchased from the Superintendent of Documents, U.S. Government Printing Office, Washington, DC 20402.
Limited Warranty
See our Terms and Conditions for more details.
Usage with 3rd party devices
Please note that while efforts are made to follow the PC/104 specification this peripheral is not tested with third party SBCs or connected peripherals. This card is not guaranteed to operate as intended when third party PC104 peripherals or SBCs are connected.