D
|
- Changed PHY to Marvell 88E1512 due to published Microchip errata #9-10 which affects link reliability with some link partners.
Note:
|
This change should be transparent in Linux from older kernels, but if link problems are seen from older images make sure the Marvell PHY driver is actually disabled as it does not configure this PHY correctly. The genphy driver will communicate correctly with this PHY. Earlier shipping images had this enabled, but current images keep this driver disabled
|
- Changed to a larger Ethernet Magjack with separate centertaps as required by the PHY manufacturer.
- CPU pin C13 tied to ground. Used to detect REV D boards.
- Added two lane MIPI connector (CN1)
- Changed to smaller battery holder
- Pull USB_5V_DETECT on silabs low when CON_EN jumper is off. This fixes the bug on previous revisions which would cause the board to fail to boot when CON_EN is off and USB is connected on the P2 port before the TS-7970 is powered on.
- Added PUSH_SW# to HD1 which allows a pin to wake the board out of sleep.
- Changed pin 28 to Enable 2.5V REF to reduce power in silabs sleep mode
- Improvements for our internal production
|