Search results

*Connect the GND and POWER screw terminals to a voltage source from 10V to 30V DC. *Apply power

...take appropriate Electrostatic Discharge (ESD) precautions. Disconnect the power source before moving, cabling, or performing any set up procedures. Inappr ...s 5-28VDC input on the terminal block connector, and commonly has a 12-15W supply.

| {{ProductPreview|File:TS-8160.jpg|TS-8160|TS-8160|PC104, CAN, Low Power}} | {{ProductPreview|File:TS-8150.jpg|TS-8150|TS-8150|PC104, CAN, Low Power}}

...ition, it makes board utilization easier by bringing out a regulated power supply and computer's I/O interfaces through standard connectors. Power over Ethernet

...e up to 1400mA, but this is a shared 5V rail and will depend on your power supply and what other devices are using that rail.

*Connect the GND and POWER screw terminals to a voltage source from 10V to 30V DC. *Apply power

...take appropriate Electrostatic Discharge (ESD) precautions. Disconnect the power source before moving, cabling, or performing any set up procedures. Inappr ...s on power requirements, differences between builds, and options to reduce power.

...e up to 1400mA, but this is a shared 5V rail and will depend on your power supply and what other devices are using that rail.

...rts the [[TS-5300]] and the [[TS-3300]] SBC models. The optional switching power regulator converts 10-30 VDC to regulated +5 VDC required by the SBC. ...tors on the back-side of the enclosure. It is also used to supply/regulate power

The TS-7970 includes two removable terminal blocks (OSTTJ0811030) for power, UARTs, CAN, and other general purpose IO. | Power Input (8-28VDC)

== Power Specifications == == Power Consumption ==

* The switching power regulator efficiently converts 12-38 VDC to regulated +5 VDC required by th * Power Good LED visible on the rear panel

== Power Specifications == ...ted at a time, connecting both may cause damage to the device or the power supply.

jumper selectable 3.3V or 5V power supply. TS-MODEM2 supports all MultiTech "Socket * Power to the socket modem is jumper selectable for either 3.3V or 5V

...5600 Single Board Computer and two PC/104 peripheral boards. The switching power regulator efficiently converts 12-38 VDC to regulated +5 VDC required by th * Power Good LED visible at back panel

== Power Specifications == ...the at any time; supplying both inputs may cause damage to the TS-7970 or power supplies.

...00]] Single Board Computer and two PC/104 peripheral boards. The switching power regulator efficiently converts 12-38 VDC to regulated +5 VDC required by th * Power Good LED visible at back panel

...5500 Single Board Computer and two PC/104 peripheral boards. The switching power regulator efficiently converts 12-38 VDC to regulated +5 VDC required by th * Power Good LED visible at back panel

...gle Board Computer. The switching power regulator converts 20-30 VDC input power to regulated +5 VDC required by the SBC. The TS-ENC200 also provides an IDE ...tors on the back-side of the enclosure. It is also used to supply/regulate power to the enclosed board(s), and for controlling the various LEDs.

|data22 = 8-30V switching power supply * 8-30V switching power supply